E.MC pneuamtics started designing and manufacturing pneumatic cylinder at the very beginning, and now we have a wide range of pneumatic cylinders from standard cylinders to nonstandard cylinders, and from small bore size of 6mm to 600mm.

We have tie-rod air cylinder for Asia market and ISO6431/VDMA24562 standard pneumatic cylinder for international market, also we have square cylinder according to DIN24335 standard, compact cylinder and ISO6432 round cylinders are in mass production, the double shaft, guided cylinder, slide cylinder, pen cylinder, needle cylinder are also provided as normal.

With 21 years sufficient expenrience and strong technique support, E.MC pneumatics also designs different kind of pneumatic cylinders according to customers requirement.For any special pneumatic cylinder requirement please contact us freely .

High quality is always considered as one of the most important E.MC culture and team spirit style.From the cylinder end cover, to piston, seal, bolts......Every parts of E.MC pneumatic cylinders are checked very strictly to make sure the quality is superior and can be supplied to any customer very proudly.

Pneumatic cylinder:

Attention for installation & operation
Before installation, the cylinder should be first subjected to preliminary operation
under unload condition and accepted as qualified.
Choose the installation types according to the service conditions and note the following
clauses with care during installation.
A.The apply force should be on the same plane when mounting the tongue and intermediate
shaft pin.
B.When mounting the flange ,the apply force and the support center should be on the
same shaft axis, The flange and the flange the fulcrum bearing should with connected
that the flange face is subjected to the apply force but not the set screw
subjected to the tensile force.
C.The air cylinder piston rod should not be subjected to unbalance loading or lateral
load. The air cylinder with over-length travel should be equipped with supporting
device or guide means. Before connecting the air cylinder to the pipe, the
pipe should be first cleaned out so as to prevent waste from entering the air
cylinder. Fastenings should be often checked up in order to avoid losing.
If it is necessary, the throttle-valve can be regulated to adjust the buffer effect
and protect the piston from colliding with the cylinder head, which may damage
the parts.  hydraulic cylinder

Type    Bore size   Stroke     Inside magnet    Mounting type 

DNC:Fixed Type                   

Double acting                              

Specification: